How To Drill A Hole In Ceramic Tile For Plumbing

  • Post author:
  • Post category:teh
  • Post comments:0 Comments

How To Drill A Hole In Ceramic Tile For Plumbing. Measure and mark the tile. Mark it with a pencil, pen, or a piece of chalk.

Cutting a Hole for Tap in Ceramic Tile YouTube from

A variety of sizes ensures that your work is accurate and secure. Next carry these lines around to the back of the tile and reproduce them. Use duct or masking tape over the surface area of the ceramic tile where the hole is to be drilled.

If We Are Talking About Glossy Tile Material, You Should Cover The Place Of Cutting With Adhesive Tape, Adhesive Tape.

Be sure to put in enough to cover the tile. Measure and mark the location of the holes. A variety of sizes ensures that your work is accurate and secure.

Tape A Makeshift Cardboard Tray Under The Point Where You Will Drill To Catch The Dust.

Inside the rectangle formed by the intersecting lines, draw the same circle on the back of the tile. On the area of the hole must be marked out with a marker mark the contour on the outer side of the tile. Fill the mound half way with your air tool oil.

This Short Video Shares How To Use The Mondrillo Black To Drill A Large Hole In Ceramic Tile In 10.

Two for each shower head, two for each tub spout, one for a handheld shower spray, two each for any water supply lines coming up from a tile floor. Do not have your drill on the 'hammer' setting as that may crack the tile. So you need to cut a hole in a ceramic, porcelain or even marble tile, in this video o will show you how to drill a hole any size you need without having to.

First, Drill A Starter Hole With The Masonry Bit.

Measure and mark the tile. If it can go through concrete, it can get through a porcelain tile. Here are two different ways:

Mark It With A Pencil, Pen, Or A Piece Of Chalk.

This is the area you are going to drill through. Duct and masking tape is easier to write on than the ceramic tile itself. Drill a hole in ceramic, porcelain, clay, or tile.

Leave a Reply