How To Reset Oil Change Light Jeep Grand Cherokee References. Reset oil change required light on 2008 jeep grand cherokee Without holding the brake pedal, press the start/stop button to turn on the electronics.

Jeep Cherokee 2015 in Lodi, Saddle Brook, Garfield, Hasbrouck Heights from www.europeanautoexpo.com

Turn the ignition on but don't start the engine, or press the start push button twice. Then three times in a row, quickly press down on the gas pedal, all within five seconds. Then press & hold the reset button until the mileage resets.

This Video Is About How To:

Put the transmission in park position and key in on position. Jeep wrangler oil change maintenance light (this is where i do not get the oil life reset option it just goes to the battery voltage screen) 5.

Push The Gas Pedal To The Floor Three Times (Within Ten Seconds).

Reset oil change required light on 2008 jeep grand cherokee The fastest way to reset oil life and is usually used for all jeep models is by step on the gas pedal three times slowly within 10 seconds after turn the ignition to the run position. Turn the ignition to the “on” notch, without starting the engine.

Thank You For Using Car How To And The Oil Reset Pro App.

Shift the gear to the “park/p” position. Please click oil reset to see the process for other car. Press the start/stop button to turn the electronics off.

Then Three Times In A Row, Quickly Press Down On The Gas Pedal, All Within Five Seconds.

Turn the ignition on but don't start the engine, or press the start push button twice. Press and release the right arrow button to access the ”oil life” screen. Turn the ignition back off and then start the car up normally again.

On The Steering Wheel, Navigate To The “Oil Life” Selection Under “Vehicle Info“.

Push and hold the ok button until the oil light percentage changes to 100%.; Do not start the engine. Press and hold the right arrow button for one second to access the ”oil life reset” screen.

Leave a Reply

Your email address will not be published.